Needle Roller Clutch Pressbearings, Drawn Cup

• Drawn Cup Needle Roller Clutch
• Carbon Steel Housing, Black Oxide Finish

Features:
• Self-clinching
• Nonaligning
• Knurling ensures secure self-clinching
• Simple quick installation
• Major assembly and production savings
• Mounting blocks not necessary

Operating Temperature:
-30°C to +120°C

NOTE:
1. The direction of rotation is when viewed from the serrated end of the bearing.
2. Hardened steel shaft required.

INSTALLATION:

1. Punch or drill and ream a hole of diameter d1 in panel as specified in the Design Parameters table.

DO NOT DEBURR OR BREAK EDGE OF HOLE.

2. Place bearing assembly in hole. The slight interference fit assures centering the assembly in the mounting hole.

3. Using an anvil with diameter d2, a minimum depth of K and a punch diameter of D2, press the bearing assembly into the panel by constantly applying a force of F, per the table, until the assembly is flush with the panel surface.

DO NOT USE HAMMER BLOWS!

Nom. Shaft Dia.	d2 Anvil Dia. +0.1	K Min. Anvil Depth	D2 Min. Punc Dia.	CL Min. Dist. Centerline to Panel Edge	Installation Force F Cold-Rolled Steel tons
6	16.35	28.8	22	11.5	49
8	22.65	30.4	28	16	50

SHAFT RECOMMENDATIONS:
Shafts should be hardened to HRC 58 to 64 with a 0.4 µm finish. Shaft ends should have radii or be chamfered.

Shaft Diameters

Nominal Shaft Diameter	Min. Diameter	Max. Diameter
6	5.992	6.000
8	7.991	8.000