PRESSBEARINGS | Sintered Bronze - Carbon Steel Retainer, Metric

• Oil-Impregnated Sintered Bronze Bearing SAE 840
• Carbon Steel Retainer, Black Oxide Finish

Features:
• Press-fit installation • Self-aligning to ±5° • Self-Lubricating

Operating Temperature:
-29°C to +93°C

Pressbearings Sintered Bronze Installation

INSTALLATION:

1. Punch or drill and ream a hole of diameter d1 in panel as specified in the Design Parameters table.

DO NOT DEBURR OR BREAK EDGE OF HOLE.

2. Place bearing assembly in hole. The slight interference fit assures centering the assembly in the mounting hole.

3. Using an anvil with diameter d2, a minimum depth of K and a punch diameter of D2, press the bearing assembly into the panel by constantly applying a force of F, per the table, until the assembly is flush with the panel surface.

DO NOT USE HAMMER BLOWS!

TOOLING & INSTALLATION DATA

Nominal Shaft Diameter	d1 Panel Hole Diameter +0.07	d2 Anvil Dia. +0.1	K Min. Anvil Depth	D2 Press Tool Min. Dia.	CL Min. Dist. Centerline to Panel Edge	Installation Force
						F
						Cold-Rolled Steel tons
4	12.7	13.15	15.2	19	9.5	45000
6	12.7	13.15	15.2	19	9.5	45000
8	15.9	16.35	16.5	22	11.5	49000
10	15.9	16.35	16.5	22	11.5	49000
12	20.6	21.05	21.3	27	12.7	49000
15	27	27.45	24.4	33	19	54000
18	31.8	32.25	27.5	38	19	54000

SHAFT RECOMMENDATIONS:
Finish: 4 µm or finer.
Material: Cold-rolled steel, drill rod, hardened and ground steels, or nonaustenitic stainless steel.

INSTALLATION NOTES:
1. The punch must be relieved to accommodate protruding insert.
2. DO NOT PRESS BEARING ON INSERT!