• Drawn Cup Needle Roller Clutch
• Carbon Steel Housing, Black Oxide Finish
Features:
• Self-clinching • Nonaligning
• Knurling ensures secure self-clinching
• Simple quick installation • Major assembly and production savings
• Mounting blocks not necessary
Operating Temperature:
-30°C to +120°C
NOTE:
1. The direction of rotation is when viewed from the serrated end of the bearing.
3. Hardenned steel shaft required.
 |
INSTALLATION:
1. Punch or drill and ream a hole of diameter d1 in panel as specified in the Design Parameters table.
DO NOT DEBURR OR BREAK EDGE OF HOLE.
2. Place bearing assembly in hole. The slight interference fit assures centering the assembly in the mounting hole.
3. Using an anvil with diameter d2, a minimum depth of K and a punch diameter of D2, press the bearing assembly into the panel by constantly applying a force of F, per the table, until the assembly is flush with the panel surface.
DO NOT USE HAMMER BLOWS!
|
TOOLING & INSTALLATION DATA
Nominal
Shaft
Diameter |
d2
Anvil
Dia.
+0.1 |
K
Min.
Anvil
Depth |
D2
Min.
Punch
Dia. |
CL
Min. Dist.
Centerline to
Panel Edge |
Installation
Force |
| F |
Cold-Rolled
Steel N |
| 6 |
16.35 |
28.8 |
22 |
11.5 |
49 |
| 8 |
22.65 |
30.4 |
28 |
16 |
50 |
|
 |
SHAFT RECOMMENDATIONS:
Shafts should be hardened to HRC 58 to 64 with a 0.4 µm finish. Shaft ends should have radii or be chamfered.
|
SHAFT DIAMETERS
Nominal
Shaft
Diameter |
Minimum
Diameter |
Maximum
Diameter |
| 6 |
5.992 |
6.000 |
| 8 |
7.991 |
8.000 |