• Drawn Cup Needle Roller Bearing
• Carbon Steel Housing, Black Oxide Finish

Features:
• Self-clinching • Self-aligning to ±5° or nonaligning
• High-speed, high-load applications • Knurling ensures secure self-clinching
• Simple quick installation • Major assembly and production savings
• Mounting blocks not necessary

Operating Temperature:
-30°C to +120°C

NOTE: Hardened steel shaft required.
 

 

INSTALLATION: 1. Punch or drill and ream a hole of diameter d1 in panel as specified in the Design Parameters table. DO NOT DEBURR OR BREAK EDGE OF HOLE. 2. Place bearing assembly in hole. The slight interference fit assures centering the assembly in the mounting hole. 3. Using an anvil with diameter d2, a minimum depth of K and a punch diameter of D2, press the bearing assembly into the panel by constantly applying a force of F, per the table, until the assembly is flush with the panel surface. DO NOT USE HAMMER BLOWS!

TOOLING & INSTALLATION DATA Nominal Shaft Diameter d2 Anvil Dia. +0.1 K Min. Anvil Depth D2 Min. Punch Dia. CL Min. Dist. Centerline to Panel Edge Installation Force F Cold-Rolled Steel N SELF-ALIGNING 4 16.35 16.6 22 11.5 49000 6 16.35 16.6 22 11.5 49000 8 21.05 21.3 27 12.7 49000 10 21.05 21.3 27 12.7 49000 12 27.45 24.5 33 19 54000 15 32.25 27.5 38 19 54000 NONALIGNING 4 13.15 15.8 19 9.5 45000 6 16.35 15.8 22 11.5 49000 8 16.35 16.1 22 11.5 49000 10 21.05 17.7 27 12.7 49000 12 21.05 17.7 27 12.7 49000

SHAFT RECOMMENDATIONS: Shafts should be hardened to HRC 58 to 64 with a 0.4 µm finish. Shaft ends should have radii or be chamfered. INSTALLATION NOTES: 1. The punch must be relieved to accommodate protruding insert. 2. DO NOT PRESS BEARING ON INSERT!

SHAFT DIAMETERS

Nominal Shaft Diameter	SELF-ALIGNING		NONALIGNING
	Minimum Diameter	Maximum Diameter	Minimum Diameter	Maximum Diameter
4	3.992	4.000	3.992	4.000
6	5.992	6.000	5.992	6.000
8	7.991	8.000	7.991	8.000
10	9.991	10.000	9.991	10.000
12	11.989	12.000	11.989	12.000
15	14.989	15.000	14.989	15.000