PRESSBEARINGS | Delrin - Carbon Steel Retainer, Inch

• Oil-Impregnated Sintered Bronze Bearing SAE 840
• Carbon Steel Retainer, Black Oxide Finish
• FDA Approved Material

Features:
• Press-fit installation • Self-aligning to ±5° • Self-Lubricating

Operating Temperature:
-40°F to +300°F

INSTALLATION:

1. Punch or drill and ream a hole of diameter A in panel as specified in the Design Parameters table.

DO NOT DEBURR OR BREAK EDGE OF HOLE.

2. Place bearing assembly in hole. The slight interference fit assures centering the assembly in the mounting hole.

3. Using an anvil with diameter N, a minimum depth of O and a punch diameter of P, press the bearing assembly into the panel by constantly applying a force of F, per the table, until the assembly is flush with the panel surface.

DO NOT USE HAMMER BLOWS!

TOOLING & INSTALLATION DATA

Nominal Shaft Diameter	A Panel Hole Diameter +.003 -.000	N Anvil Dia. +.005 -.000	O Min. Anvil Depth	P Min. Punch Dia.	CL Min. Dist. Centerline to Panel Edge	Installation Force
						F
						Cold-Rolled Steel tons
3/32	.234	.249	.39	.48	.19	1.0
1/8	.297	.312	.43	.54	.22	1.5
3/16	.375	.390	.48	.62	.25	2.0
1/4	.375	.390	.48	.62	.25	2.0
5/16	.547	.562	.59	.80	.41	5.0
3/8	.625	.640	.71	.87	.45	5.5
1/2	.812	.827	.87	1.07	.50	5.5
5/8	1.063	1.078	.97	1.31	.75	6.0
3/4	1.250	1.265	1.09	1.50	.75	6.0

SHAFT RECOMMENDATIONS:
Finish: 16 µin. or finer.
Material: Any material with the above finish.

INSTALLATION NOTES:
1. The punch must be relieved to accommodate protruding insert.
2. DO NOT PRESS BEARING ON INSERT!