• Delrin Bearing
• Carbon Steel Retainer, Black Oxide Finish
• 303 Stainless Steel Retainer
• FDA Approved Material

Features:
• Press-fit installation • Self-aligning to ±5° • Self-Lubricating

Operating Temperature:
-40°C to +149°C
 

The projections shown are per ISO convention.
 

INSTALLATION: 1. Punch or drill and ream a hole of diameter d1 in panel as specified in the Design Parameters table. DO NOT DEBURR OR BREAK EDGE OF HOLE. 2. Place bearing assembly in hole. The slight interference fit assures centering the assembly in the mounting hole. 3. Using an anvil with diameter d2, a minimum depth of K and a punch diameter of D2, press the bearing assembly into the panel by constantly applying a force of F, per the table, until the assembly is flush with the panel surface. DO NOT USE HAMMER BLOWS!

TOOLING & INSTALLATION DATA Nominal Shaft Diameter d1 Panel Hole Diameter +0.07 d2 Anvil Dia. +0.1 K Min. Anvil Depth D2 Min. Punch Dia. CL Min.Dist. Centerline to Panel Edge Installation Force F Cold-Rolled Steel N 2 5.9 6.35 9.9 12.2 4.7 9000 4 7.5 7.95 11 13.7 5.5 14000 6 9.5 9.95 11.9 15.6 6.4 18000 8 13.9 14.35 15 20.3 10.3 45000 10 15.9 16.35 18 22 11.5 49000 12 20.6 21.05 22 27 12.7 49000 15 27 27.45 24.4 33 19 54000 18 31.8 32.25 27.4 38 19 54000

SHAFT RECOMMENDATIONS: Finish: 0.4 µm or finer. Material: Any metal with the above finish