• Delrin Bearing
• Carbon Steel Retainer, Black Oxide Finish
• 303 Stainless Steel Retainer
• FDA Approved Material

Features:
• Press-fit installation • Self-aligning to ±5° • Self-Lubricating

Operating Temperature:
-40°F to +300°F
 

 

INSTALLATION: 1. Punch or drill and ream a hole of diameter A in panel as specified in the Design Parameters table. DO NOT DEBURR OR BREAK EDGE OF HOLE. 2. Place bearing assembly in hole. The slight interference fit assures centering the assembly in the mounting hole. 3. Using an anvil with diameter N, a minimum depth of O and a punch diameter of P, press the bearing assembly into the panel by constantly applying a force of F, per the table, until the assembly is flush with the panel surface. DO NOT USE HAMMER BLOWS!

TOOLING & INSTALLATION DATA Nominal Shaft Diameter A Panel Hole Diameter +.003 -.000 N Anvil Dia. +.005 -.000 O Min. Anvil Depth P Min. Punch Dia. CL Min. Dist. Centerline to Panel Edge Installation Force F Cold-Rolled Steel tons 3/32 .234 .249 .39 .48 .19 1.0 1/8 .297 .312 .43 .54 .22 1.5 3/16 .375 .390 .48 .62 .25 2.0 1/4 .375 .390 .48 .62 .25 2.0 5/16 .547 .562 .59 .80 .41 5.0 3/8 .625 .640 .71 .87 .45 5.5 1/2 .812 .827 .87 1.07 .50 5.5 5/8 1.063 1.078 .97 1.31 .75 6.0 3/4 1.250 1.265 1.09 1.50 .75 6.0

SHAFT RECOMMENDATIONS: Finish: 16 µin. or finer. Material: Any material with the above finish.